Industrial Floor Fans – Floor fans are helpful devices that can help reduce your overall energy costs at home when used properly. Floor fans are cheap and available in a variety of home-based stores, especially during the warm months. They also use much less energy than other domestic refrigeration devices. According to the electricity saving website, a standard floor fan uses only 100 watts of power per hour, while a central air conditioner uses up to 3,500 watts. Look around the room where you want to install the floor fan and locate the electrical outlets.
This will determine the locations where the industrial floor fans can be placed so that it will not run out of wires on the ground causing a trip hazard. Adjust the fan so that the blades are directed to the location where you sit or more often. If the fan is in a room in which it moves around or when there are several people, it points it to the center of a wall, which causes the air to bounce in a circular pattern. Plug the fan power cord into the nearest electrical outlet, and cover the cord with a carpet if there is any chance that someone might trip over it. A rug also discourages pets from playing with the industrial floor fans cable.
25 Photos Gallery of: Tips Repairing Industrial Floor Fans
Turn on the fan at the lowest speed, which creates the least amount of noise. Sit in an area in front of the fan, and determine if the airflow is sufficient for your liking. If necessary, increase speed on one step at a time until you is comfortable. Industrial floor fans provide air movement and help maintain air temperature in both warm and cold temperatures. The fan blades spin at a high speed, pushing air forward and creating a breeze. The air is filled with dust and debris that, over time, affect the performance of the industrial floor fans. Routine repairs will keep the fan running at a higher efficiency level and will also increase the floor fan life.
Place the fan standing on a flat work surface. Remove the screws that hold the protective cover in place and set it aside in a safe place. Turn on the industrial floor fans and remove the protective cover back. Clean the motor with a cloth to remove any dust and dirt. Spray with compressed air to clean the small corners and cracks of the engine. Lubricate the engine with the WD-40 to make it easier for the engine to rotate the industrial floor fans blades. Clean the front and back of each fan blade with a disinfectant solution. Place the protective covers on the front and rear of the floor fan.