Modular wine rack – Properly stored wine can stay fresh for years or even decades. However, when wine bottles are kept standing, the cork can dry out and become brittle, allowing the air to pass through and spoil the wine. The bottles in horizontal position keep the cork moist and the seal intact. However, this is not a problem for wines sealed with synthetic caps or caps. These wines are stored safely in an upright position.
It’s always nice to go to a bar or restaurant and watch the wine glasses hanging neatly over your head or in the modular wine rack. It makes you feel that everything is ready for you to sit down and have a drink.
25 Photos Gallery of: The Modular Wine Rack to Store Wine
Where to Store Wine
Laying the bottles horizontally is one of several suggestions for storage. Choosing the location will also help protect you. The ideal storage temperature is 50 to 59 degrees Fahrenheit (10 to 15 degrees Celsius). Ideally, the wine will be stored in moisture levels from 50% to 70%. The vibration can loosen the plug and allow air to pass through the dry cork. Do not store wine on top of a refrigerator or near any source of vibration. The ultraviolet (UV) rays of the sun damage the wine over time. In addition, strong odors can penetrate the cork and affect the taste of the wine. Select modular wine rack the place where you store it away from light and smell.
Easy to Store Bottles Safely Modular Wine Rack
Wine racks make it easy to store bottles safely. Simply place them horizontally, because, without one, they can move or break. These shelves range from simple models, for just a few bottles, to a complex system for a wine cellar. Choose the place where you will store the wine before choosing the shelf. This will determine how big you should buy it. Next, consider how many bottles you expect to store.
If you do not want to have to look for the wine glasses in a closet and you would like to have them hanging and ready for you, look at these suggestions.
Support the two short wooden slats parallel to each other. This will create the base of the wine glasses holder. Mark sections with 1.5 inches (3,81 cm) apart from each other with your pencil on each batten so you have seven sections on each batten. Put the longer slats on top of the marked wood, leaving an open section between each. You should have four slats with three openings.
Drill pilot holes in the center of each end of the long strips and at the base. Screw each top rail into place using the wood screws. Put one of your wine glasses in the internal space of the two external empty sections. It will overlap on both sides where it rests on the wood. Trace the contour of the glass in the wood. Do the same for the middle section, only at the other end.