Wall lamps with cord – Installing wall lamps with a cord in a single circuit will allow you to use only one switch. And save space in the switch box for different circuits in the future. Calculate the amperage of your lights combined with the amperage of the circuit so it is not over charged. You should also use the only electrical cable that is the same as the circuit you are installing it on. Installation is simple if you follow the right steps, and you will save money if you do it yourself. This article will explain how to install multiple lamps in a single circuit.
A new lighting device mounted on the ceiling or on a wall lamps with cord can rejuvenate the decor of the room. The new lighting devices have three wires for the electrical connection. The wiring of the luminaire consists of a hot, a neutral and a ground. Many old houses were wired with hot and neutral wires, but they do not have the ground wire. Even so, a new lamp can be connected, even if there is no grounding in the house wiring system.
27 Photos Gallery of: How To Install Wall Lamps With Cord In A Single Circuit
Instructions Install Wall Lamps with Cord
Turn off electricity from the switch box using the main switch. Pass a cable from your lamp to the existing lamp where you want to tie it if you want them to be turned on with the same switch. If you are using a different ignition switch, you will need to route the cable from your new lamp to the new switch. Then pass another cable from the new switch to the existing switch on the bottom of the wall. And using wire clips to hold the wire in the socket and then following the old wire on the wall to the old switch. Unscrew the central screw of the old switch faceplate. Loosen the two inner screws, then pull it towards you.
For 1 inch (2.5 cm) of cable. If you are using an existing switch to control all the wall lamps with cord, you can tie the new lamp to the previous one. Unscrew the existing lamp and pull it towards you. Place the new cable through the conduit box and wind the black and white cable to the existing ones. Attach a plastic cover to protect them. If you are placing a new switch, you will need to attach the wire to the existing switch. Once your new cable is connected to the old switch, screw the black wire to the lower switch screw. Roll the white wires together and place a plastic cap.
Screw the above switch back in and replace the faceplate. Turn on the electricity again when you finish the installation. Try your installation.