Polished nickel kitchen faucet – Choosing a kitchen sink faucet is an important decision. While design is a major determinant, cost and function must also be taken into account. According to Kitchen Remodeling Designs, a site dedicated to kitchen remodeling, most kitchen faucets come with a lifetime warranty, providing potential buyers with a larger selection in the search for the faucet Perfect for your home. A leaking sink faucet, though it does not look like much, can end up costing you money in the long run. According to the US Environmental Protection Agency, leaking faucets in the home can drip, to over 10,000 gallons over the course of a year.
Most of the faucet leaks are caused by a malfunctioning valve stem or a washing machine, which control the flow of water through the faucet. By changing the stem or replacing the washer, you can fix a faucet sink that escapes itself and save money on a repair bill as well as stop wasting water. Turn off the water supply for the polished nickel kitchen faucet. Look under the sink and locate the second round or oval shaped water supply valves. They rotate clockwise to close the water supply. Turn on tap and allow water to drain inside. Examine the top of the faucets to locate the faucet screw cap.
25 Photos Gallery of: How to Fix Polished Nickel Kitchen Faucet
They are usually hide the “cold” tags on the “hot” taps or. Leverage this with the edge of a flat-head screwdriver. Remove the faucet screw with a Phillips screwdriver. Lift the handle cock up and out. Remove the upper hex nut on the valve stem with a wrench. Unscrew the second hexagonal screw, which is the valve stem itself. Lift the valve stem from the polished nickel kitchen faucet. Examine the valve stem. Replace if cracked or worn. Clean calcium deposits with a piece of steel wool. Turn the rod down and examine the washer at the bottom. If it is cracked, split or broken, it must be replaced.
Fix polished nickel kitchen faucet, remove the old washer by loosening the retaining washer screw with a screwdriver. Replace with a new washer. Insert and tighten the screw. Apply a pipe thread compound to the threads on the stem. Insert it into the stem housing and tighten. Slide the second hex nut onto the stem and tighten. Replace to replace the faucet. Insert and tighten the handle screw. Replace tap screw cap and press into place. Reset the water supply by turning the valves to the left. Run the faucet and check its correct functioning.